80 Percent Builder Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Pages: 1 2 [3]

Author Topic: 5D Tactical router based Jig  (Read 670 times)

Jefe

  • Administrator
  • *****
  • Posts: 385
    • View Profile
Re: 5D Tactical router based Jig
« Reply #30 on: June 07, 2017, 02:21:15 PM »


I tried that and it did not work. The 1/4" end mill was biting into the guide plate bearing on the jig. I was attempting to use the 1/4" end mill for the bulk of removal and then the 5/16" end mill to clean up the sides. I may try again because, theoretically, that should work.

So you used just the two pilot holes and tried to remove the bulk of the FC pocket with the 1/4" std end mill?   

Chatter City ??

That's correct.
Logged
Pages: 1 2 [3]